Used Versalift SST-40-EIH-02 equipped as follows:
- 45 ft. working height
- Platform capacity of 350 lbs
- End mounted closed 24 in. x 30 in. x 42 in. fiberglass platform with one step, liner, and cover
- Versalift TruGuard™ dielectric isolating system with right hand single stick control. All control handles are isolated and tested per ANSI 92.2. The high resistive dielectric system is protected from direct environmental and job-related contamination. TruGuard™ technology incorporates the use of full hydraulic controls with durable metal handles and linkages
- 180° hydraulic platform rotator
- Full pressure turret mounted lower controls including override
- Engine start/stop system with controls at platform and lower controls
- Continuous unrestricted rotation including three pass collector ring
- Five GPM open center hydraulic system
- Chassis insulating system (lower boom insert) including fiberglass compensation link providing 12 inches insulation gap
- Fiberglass inner boom and patented Electrogard providing 42 in. insulation gap fully retracted meeting ANSI A92.2 requirements for Category C, 46 KV and below
- Hydraulic tool power at bucket. Quick disconnect couplers not included
- Electrogard and inner boom finished with white urethane paint over white gel coat
- Integral hydraulic oil reservoir with dual sight gauges and 15 gal. capacity
- Master/slave hydraulic leveling with upper control to tilt for clean-out and rescue. Leveling control at lower controls
- Non lube bearings used at all pivot points
- Multi link hose carrier system through booms
- Boom cradle and ratchet type tie down strap
- Automatic throttle control
- 12 Volt DC backup pump providing power to all boom functions
- Mounting hardware for chassis/cab installation
- Full body harness and lanyard
- Painted standard white urethane
132” Steel Service Body equipped as follows:
- 132” long x 40” high x 94” wide
- 24” tread plate tail shelf
- LED lighting package installed in tail shelf
- Cable access step at rear and side access
- Two (2) chrome grab handles at side access and two (2) pool type grab handles for rear tail shelf
- Wheel chock storage on curbside
- Door lock hook and loop system
- Curbside compartments as follows
- 1st Vertical: (2) adjustable shelves with dividers
- 2nd Vertical: Grip strut access steps to bed area with removable composite side gate
- Horizontal: Open
- Rear Vertical: (5) fixed material hooks 1-3-1
- Street side compartments as follows
- 1st Vertical: (2) adjustable shelves with dividers
- 2nd Vertical: (1) adjustable shelf with dividers
- Horizontal: Open
- Rear Vertical: (2) adjustable shelves with dividers
- Hotstick top box with door at rear
MOUNTED ON:
2022 Ford F550 4x4 equipped as follows:
- 19,500 lb GVWR
- 6.7L Power Stroke V8 turbo diesel engine
- TorqShift 10-speed automatic transmission
- Engine block heater
- 225/70Rx19.5 tires
- Power locks and windows
- Cruise control
- 40/20/40 vinyl bench
- AM/FM radio
- Painted white
*Monthly payment stated above assumes a secured commercial use loan transaction available for highly qualified commercial loan applicants. Actual loan payment amount and terms may vary. Consumer financing not available for consumers residing in Nevada. Additional state restrictions may apply. Equal opportunity lender. Click here for more state licenses and disclosures. NMLS ID: 1857954. VERMONT RESIDENTS: THIS IS A LOAN SOLICITATION ONLY. CurrencyFinance IS NOT THE LENDER. INFORMATION RECEIVED WILL BE SHARED WITH ONE OR MORE THIRD PARTIES IN CONNECTION WITH YOUR LOAN INQUIRY. THE LENDER MAY NOT BE SUBJECT TO ALL VERMONT LENDING LAWS. THE LENDER MAY BE SUBJECT TO FEDERAL LENDING LAWS. CALIFORNIA RESIDENTS: Financing provided or arranged by Express Tech-Financing, LLC dba Currency pursuant to California Finance Lender License #60DBO54873
Your current browser cannot run our content, please make sure your browser is fully updated or try one of the browsers below.